MM bot configuration

[xxxsublimexxx111]

I have a few too many gc's in my inventory i guess cuase bot always says too many gc's ending and i need them how can i modify the script ==>what part of the configuration? Thnx guys <== srry guys i figured it out answer below question tho... im retarded

Oh another question is dclone hunter a descent program? does it just find the ip or does it fight dclone 4 u? any advise on this matter helpful too

[Shift]

It is in the mm.bot config. It looks like this.


;################################################# #############################
;
; DEFAULT INVENTORY & REPAIR PREFERENCES
;
; * Char_MiniFreeSpaces => At how much free spaces letf in inventory the bot
; will stop. Never let the bot continue to run while inventory & stash are full.
; NOTE: If you make multiple monsters and pickup rare you should have 24+ !
; If you are only pickup few uniques you can decrease the value to 12-16.
;================================================= =============================
; * Char_ForceRepairCycle => Will force a repair to Larzuk every xx runs.
; If value = 0 auto check repair is activated at the start of each run.
; Damaged armors/Helms/etc... And -melee- weapons are automaticly detected.
; Its recommended to force/define a cycle, since the auto check burn ~500 ms
; If you have a sorce give 100 (repair every 100 runs...It's an example.)
;================================================= =============================
Char_MiniFreeSpaces = 24
;================================================= =============================
Char_ForceRepairCycle = 100
;================================================= =============================

The one in bold is the one you change, I think.

[xxxsublimexxx111]

Thnx man i was able to figure the inventory out but i got another situation

the bot loads up and kills pindle... he gets reallt close almost on top of hime but its okay there
After pindle the bot id's stuff and goes to frigid wp the bot tele's into a corner out of sight and no where near the green box then the bot aborts. how do i fix the cordinates i cant understand the sequences part of the manual or the command part of the manual if ne one has had this problem plz inlude simple fix instructions

Also its almost as if the bot wants to use a cta and i dont got one so how do i fix that it may part of the problem.

[xxxsublimexxx111]

Help plz im so computer illiterate and ive never used a bot reading commands is like reading an alien language to me help plz I LOVE U LONG TIMEE!!!

I dont want to start a new tread plz help!